3D scanning system to reverse engineer left hand drive components to to right hand drive as well as special product development.
December 2012 – We acquired Photogrammetric systems for large project scanning and imaging.
RAPID PROTOTYPING SYSTEM
January 2013 – Autogroup installs the largest 3D rapid prototyping system available with the ability to produce 3D objects 400 x 400 x 400 MM in size.
March 2013 – Introduction of CNC equipment for detailed metal cutting.
April 2013 – Introduction of Oscilloscopes. Oscilloscopes are used to observe the change of an electrical signal over time. Such that voltage and time describe a shape which is continuously graphed against a calibrated scale. The observed waveform can be analyzed for such properties as amplitude, frequency, rise time, time interval, distortion and others. Modern digital instruments may calculate and display these properties directly. Originally, calculation of these values required manually measuring the waveform against the scales built into the screen of the instrument.
ROCKWELL STANDARDS TESTER
August 2013 – Introduction of Rockwell Standards Tester. The Rockwell scale is a hardness scale based on indentation hardness of a material. The Rockwell test determines the hardness by measuring the depth of penetration of an indenter under a large load compared to the penetration made by a preload. There are different scales, denoted by a single letter, that use different loads or indenters. The result is a dimensionless number noted as HRA, where A is the scale letter.
When testing metals, indentation hardness correlates linearly with strength. This important relation permits economically important nondestructive testing of bulk metal deliveries with lightweight and even portable equipment. such as hand held Rockwell hardness testers.
August 2013 – Introduction of Crack Testing Machine.
THREAD ROLLING MACHINE
December 2013 – Autogroup purchased and installed the Thread Rolling Machine. This machine has many methods of generating threads, including subtractive methods (For thread cutting and grinding etc.)